Licensed Electricians, Plumbers & AC Repair Company in Atlanta

I returned to Mark’s house to replace the blower motor and the circuit board on the main system of necessary. During the repair we discovered the board was working properly and didn’t need replacing, once I replaced the blower I started testing the system and discovered the airflow was high and the refrigerant was low. I adjusted the airflow to be proper and added refrigerant with Mark’s permission. On the basement system I didn’t discover any issues after I adjusted the airflow but there was water in the pan which was likely coming from the drain line as it was barely inside the condensate pump and spilling lightly over the side into the pan. I adjusted the drain line so it was solidly inside the pump to prevent any more spillage.

Performed 1 system diagnostic for bonus back room unit. Found blower motor missing new housing and blower wheel left in crawl along with old housing and rusted blower wheel left in crawl. Found growth in cabinet of air handler as well as dirty and growth.build up on heat strips,unit will need run capacitor and mounting bracket, evap coil is dirty, returned had excess dirt, condenser unit is compacted with dirt as well. Pitted contactor and recently replaced capacitor. Unit is 23 years old and R22 would recommend replacement. However repair options are available. Based on our findings today, it might be time to think about getting a brand new system.

Called out today due to water leaking from system, drain line was clogged, cleaned drain line today. Evap coil had biological growth, did a basic clean on the evap coil and installed blue tube uv light. Homeowner signed up for a membership today. System on and cooling.

For this job, I worked on troubleshooting outside shed outlet that had lost power. There was bad wiring inside switch box and GFCI was defective. Replaced GFCI outlet.

Condenser coil cleaning.

Customer toilet was clogged with the plastic fork, customer said blockage just happened often, and inform the customer that it was due from week, flush and toilet if they didn’t hold the lever long enough, customer decided to swap out with new Kingston Kohler toilet, I removed old toilet and hold it off and set new toilet with seal and after testing no leaks or cracks in toilet

Replaced customer supplied Moen smart Flo turbine, flushed out tankless water heater and replaced tub spout. Tested and inspected. Everything is working properly.

Flushed water heater. Replaced thermal expansion tank

Kitchen Faucet leaked last night and down into the cabinet below. Customer was able to tighten up the bonnet nut for the fixture. It was not leaking when we tested. The thermal expansion tank air bladder had ruptured due to age. This caused the tub/ shower valve on the main floor to drip due to excessive pressure when the water heater was heating. We removed the handle for the kitchen faucet and tightened up the bonnet nut that holds the cartridge. The shower cartridge was replaced along with the thermal expansion tank. The new thermal expansion tank was mounted to the heater per new code guidelines. We also added in a new whole house shut off valve in a more accessible area. The plumbing system was pressurized and checked for proper operation. The piping in the garage was insulated. Water pressure was safely at 60psi.

Service visit on Generac 22kw standby generator

Reseal tub

Returned to remove nest thermostat and wire in standard thermostat.

Troubleshoot tripping breaker. Troubleshoot Tesla charger overheating. Tightened connections in panel for Tesla charger and it no longer overheated.

Service visit on Generac standby generator

Replace water service line from water meter to house. Reconnect to good standing copper right at foundation of home. Remove necessary concrete to access water meter. Will not be pouring back concrete. Install gravel in place of removed concrete Thoroughly tested for leaks on water main. No leaks were found after the meter. There is an active leak before the meter. Informed and showed customer the leak, and ensured him, that it was not the new line, by showing him the meter, that it was not spinning. Also took video of leak, proving it was before the meter.

Basic Comfort 3 ton

We mounted a 55 inch TV

Electrical work

Diagnose hallway light. After completing diagnostic, we determined that we have proper voltage of 120 V at the light. It appears that the transformer on the light is bad which is not allowing light to transmit through the bulb. Sent an estimate for that

Troubleshoot

Replaced bulbs in family room chandelier Replaced fan on back deck

Trouble shot tripping breaker

Remove hose attachment from hose bib.

For this job, I worked on replacing 10 smoke detectors throughout the house. We replaced all the smoke alarms that were Original to the house.

Junction back microwave circuit to eliminate damaged part of wire and ran new wire for microwave outlet. Replaced breaker with customer supplied dual function breaker.